Mounting Brackets and Actuator Arms

Door-Aid & Adapt-A-Door Products for Commercial & Residential Handicap Use

Request a Callback

Hero Request Form

Hardware for Your Power Doors

Whether you need new or replacement hardware for your Door-Aid and Adapt-A-Door power units, be sure to contact Succour for assistance.

All our hardware is durable, affordable, and easy to maintain.

Mounting Brackets

HB1 – Header Bracket

To be used when there is no vertical stile/jamb or sufficient ceiling clearance. Requires a metal header of 3 1/2" in width. Operator installs “shaft-up” hanging from header.

HB2 – Header Bracket

To be used when there is no vertical stile/jamb, but there is sufficient ceiling clearance and at least 1" ledge of exposed header metal to bolt onto. Operator installs “shaft-down.”

HB3 – Header Bracket

DA700 – “Z” Bracket

Used to “in-swing“ a door with Door-Aid

When the existing door closer is parallel to arm or door-mounted valve body. To provide an elevated surface (level with the valve body) for the arm roller to push on.

Allows on-demand operation

Actuator Arms

AA100L – Actuator Arm with 2" Short Leg Extension

Used with center-pivot door application. This allows the elbow to reach further around the door at 90 degrees.

AA100S – Short Actuator Arm

Used as an alternative to the standard arm where needed

AA100 – Straight Arm

Used when an “in-swing” door application has insufficient sidewall clearance for the “elbow” of the standard arm